Beta Downloads — PisonetX

PisonetX LauncherNormal Mode

Standard installation using the accessibility service. For shop owners and cashiers.

Latest betav4.6.6

50.8 MB · 20 Oct 2026
pisonetxlauncherv4.6.6.apk

Current stable release: v4.3.1

Previous betas (9)

Device Owner installation for technicians — provisioning, licensing and advanced controls.

Latest betav4.6.6

50.7 MB · 20 Oct 2026
superadminmainv4.6.6.apk

Current stable release: v4.3.1

Previous betas (13)

Firmware for the ESP32 coin-slot board. Flash over USB with the SuperAdmin Manager.

Latest betav2.9.6

4.0 MB · 20 Oct 2026
pisonetx_coinslot_wifi_v2.9.6.bin

Current stable release: v2.3.3

Previous betas (6)

What’s New

A summary of this beta. Tap any item to see more detail.

v4.6.6

The timer bubble's panel has Insert Coin and Add Time buttons while a Phone Timer session runs.

The page opens full screen and shrinks back to the bubble when it closes
Insert Coin follows the dashboard's rules: it needs a vendo, and for an individual coinslot "Require INSERT COIN tap" must be on
Add Time still asks for the PIN
Admin Panel → Phone Control → "Overlay Insert Coin" and "Overlay Add Time", both on by default

The home dashboard shows Insert Coin again for Phone Timer with an individual coinslot.

Setup New Vendo can set the ESP32 pins for a custom board.

The Timer step shows a Vendo Board card listing "Standard board" and each custom board, with pictures and the pin table
Vendo Connection Settings → Custom Board shows which board matches the vendo and can switch it (Apply & Restart Vendo)
"Buy this board" opens the board's purchase link when it has one
The board list and pictures are saved on the device, so they still show on the vendo's offline hotspot

A new default background for landscape and portrait.

v2.9.6

Fixes coins that send several pulses being counted short, such as a 5-peso coin counted as 4.

Pulses are now timed the moment they happen, so none are missed while the board is beeping or talking to the phone
The coinslot stays open between the pulses of one coin
Very short glitches under 2ms are ignored as contact bounce

Coins from acceptors set to fast mode are no longer rejected.

The debug log shows each pin signal with its GPIO number and level.

For example IN GPIO4 coin pulse #3 LOW 45ms or OUT GPIO5 coin accept -> HIGH (ENABLED)
Manual enable/disable coin commands are logged too
Boot lists each pin's idle level

A full 4 MB image, flashed over USB.

There is no over-the-air update for the board
The same file is safe for every unit. It contains no WiFi, password or device ID
The full image overwrites the settings area, so run Setup New Vendo again after flashing
If the upload fails at 921600 baud, use 115200